Dennys' Home-Made Front Stand.
This is what happens when you have too much time on your hands
Total cost was about $15 and this thing is sweet.
It takes a little more work than just ordering a $100 Pitbull Stand.
Let's not count the 4 trips I made to Home Depot. I've got about 8 hours of
R&D into it.
After putting it together and ripping it apart many times, this is the final
product.
| Qty | Part Description | Where Used |
| 1 | 12" x 3/4 pipe | Handle |
| 1 | 3/4" Cap | End of Handle |
| 3 | 3/4" Tees | 1 for handle, 2 Flat to Leg transitions |
| 2 | 6" x 3/4 pipes | On the flats |
| 2 | 10" x 3/4" pipes | The support legs |
| 2 | 3/4" to 1/2" reducers | Tops of Support legs |
| 2 | 1/2" plugs | Insert on tops of Support legs |
| 2 | street elbows (female to male 90 elbows) |
Ends; as floor pivot points |
|
|
|